triumphdave
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
No I haven’t. I calibrated it yesterday to my thickest sheet and just put my thinner sheet on and all looks good.
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
Just tested this out and it works. Well spotted 👍🏻
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
Oh ok I’ll have a look in the morning 👍🏻
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
Have you found a solution?
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
Well tried it and it dosesnt work, maybe i need to change a setting in the Beacon? I calibrated the Beacon with the plate with the thicker surface then changed to the plate with the thinner surface and it was printing in the air. I feel like i am missing some thing maybe skill issue!
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
It’s the “should” part of that statement that worries me. I’ll try it tomorrow
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 10/22/2024 in #ratos-support
AWD Voron 2.4
Smashing thank you.
8 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 10/22/2024 in #ratos-support
AWD Voron 2.4
Thanks for the reply. So nothing to add for X1 or Y1. Do I need to set diag pins for x1 and y1 or just x and y
8 replies
RRCRat Rig Community [Unofficial]
•Created by CbadCruiser on 8/4/2024 in #ratos-support
Octopus Max EZ detected but is unresponsive
@CbadCruiser Hi did you manage to sort this as I have the same issue?
7 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 7/24/2023 in #ratos-support
RatOS update
4 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 7/24/2023 in #ratos-support
RatOS update
Thanks for prompt reply. That’s a bit of a coincidence as I have just updated. I will check it tomorrow thanks. 👍🏻
4 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 6/25/2023 in #ratos-support
sensorless homing
Sorted
2 replies