AWD Voron 2.4
Iām trying RatOS 2.1 RC3 on my Voron what do I have to add for sensorless homing in the printer cfg. Thanks.
4 Replies
Nothing, just select it in the hardware configurator. it will create a sensorless-homing-x.cfg and sensorless-homing-y.cfg with settings to tune (just tune it directly in those files) š
of course you need to make sure your diag pins are connected, depending on the board you're using š
Thanks for the reply. So nothing to add for X1 or Y1. Do I need to set diag pins for x1 and y1 or just x and y
You don't want to use your X1/Y1 for sensorless homing as far as i'm aware.. Too many cooks in the kitchen at that point. I'm not sure sensorless works great on AWD at all, but your mileage may vary.
You don't need to set anything, you just need to make sure your board is properly set up for sensorless homing (look in your manual for jumpers for diag pins etc)
Smashing thank you.