triumphdave
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 11/22/2024 in #ratos-support
Swapping plates
Is there a way to setup for different plates in 2.1. As beacon picks up the metal plate under the PEI sheet if you then use a different plate with thicker sticker the first layer differs. I use a PEI sheet but also a plate with FR4 stuck to the spring sheet that is thicker.
15 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 10/22/2024 in #ratos-support
AWD Voron 2.4
I’m trying RatOS 2.1 RC3 on my Voron what do I have to add for sensorless homing in the printer cfg. Thanks.
8 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 10/2/2023 in #ratos-support
Hysteresis
Is there a way to change the hysteresis for the heater. I am running a Goliath hotend and even though it has been PID tuned it struggles to settle at temp so delays the print starting.
1 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 7/24/2023 in #ratos-support
RatOS update
Just updated RatOS and I’m getting this error on homing
“ TMC 'stepper_y' reports error: DRV_STATUS: 801a0090 s2vsa=1(ShortToSupply_A!) olb=1(OpenLoad_B!) cs_actual=26 stst=1
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown”
Has anyone any ideas?
Cheers guys
4 replies
RRCRat Rig Community [Unofficial]
•Created by triumphdave on 6/25/2023 in #ratos-support
sensorless homing
Hi I’ve changed over from endstops to sensorless on my Voron but it’s homing in the wrong corner. Can somebody point me to where I can change it please. Thanks
2 replies