RatOS update
Just updated RatOS and I’m getting this error on homing
“ TMC 'stepper_y' reports error: DRV_STATUS: 801a0090 s2vsa=1(ShortToSupply_A!) olb=1(OpenLoad_B!) cs_actual=26 stst=1
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown”
Has anyone any ideas?
Cheers guys
3 Replies
Your wiring on stepper Y is bad.
Thanks for prompt reply. That’s a bit of a coincidence as I have just updated. I will check it tomorrow thanks. 👍🏻
I think this was the problem. Connector burnt out on stepper plug. Took a while to find it and a bit of a coincidence it shorted at the same time as the RatOS update.
