koekie40
RRCRat Rig Community [Unofficial]
•Created by koekie40 on 11/6/2024 in #fix-my-printer
Connecting a fan 4028 to EBB V1.2 in RatOS
i have a 4028 fan connected to my EBB 42 V1.2, and i use RatOS V2.1
i use a inverter from 24v to 12v only for this fan
the fan cables red and black are in pin: PA1
blue is connected to pin: PA3
when i try to use the slider to 100% it is not working
What am I missing here !
#############################################################################################################
FANS
#############################################################################################################
Part cooling fan
[fan]
# 2-pin fan connected to 2-pin header on T0 (EBB42 v1.2) - input voltage pwm
enable_pin: PA3
cycle_time: 0.01
7 replies
RRCRat Rig Community [Unofficial]
•Created by koekie40 on 10/23/2024 in #fix-my-printer
Problem with config my hotend with EBB 42
I have a problem with my hotend cooling, i have a EBB 42 v1.2 my hotend fan 24v. i connected to PA01, when i heat up the hotend the fan will not start. but if I use the slider bar it will start # Hotend cooling fan
[heater_fan toolhead_cooling_fan]
heater: extruder
2-pin fan connected to 2-pin header on Octopus Pro 446 - input voltage pwm
pin: toolboard_t0:PA1
15 replies
RRCRat Rig Community [Unofficial]
•Created by koekie40 on 4/1/2023 in #ratos-support
Can somebody help with this problem Z-TILT
i got some serius troubles getting Z-TILT to work
i have a V-core 3 500mm
I'm trying to setup my Z-TILT. it is not working
Config.cfg
[z_tilt]
z_positions:
0,0
250,500
500,0
points:
60,60
285,470
460,60
horizontal_move_z: 20
retries: 10
retry_tolerance: 0.02
13 replies