Vannue
RRCRat Rig Community [Unofficial]
•Created by Vannue on 2/5/2024 in #ratos-support
Restriction on Local network in custom address range in ratos 2?
Is there a testriction on Reserved private IPv4 network ranges usages.
If i want to use a non Reserved private IPv4 network ranges (not a 10...* ; 172...* or 192.168..) it seems that the ratos is not reachable anymore (Lan nor wifi) is this correct? Are there restrictions on this as my ratos 1.* versions wotks with non Reserved private IPv4 network ranges
8 replies
RRCRat Rig Community [Unofficial]
•Created by Vannue on 1/22/2024 in #ratos-support
Ratos update 1.2.4.4 to 2.0.2 - no Klipper connection
I tried a 4th attemp to do an upgrade to the latest RatOS version. With the same result as ever. No klipper connection.
Current setup RPi4 - Octopus 1.1 with all heaters, drivers & sensors etc connected. (I didn't disconnect anything before, during, after upgrade)
When I succesfully automatically or manual (same result) the Octopus board during the setup and want to proceed to the mainsail screen after step 3 I don't get Klipper responding. Thus not able to access the mainsail interface.
When I tried to reflash the MCU or simlink (3dots) I even don't get this working.
Did I overlook anything? Should I remove alle cables, stepper drivers, ... during the installation of RatOS 2.x?
I don't get it, thank you
22 replies
RRCRat Rig Community [Unofficial]
•Created by Vannue on 4/27/2023 in #ratos-support
RatOs upgrade to v2.x mainsail issue
28 replies