Quinny
RRCRat Rig Community [Unofficial]
•Created by Quinny on 4/24/2024 in #ratos-support
Turning the Heated bed off during meshing
Im using a eddy current scanner and im wanting to know if there is a easy way for me to implement turning the heated bed off while it scans, i think the 240v heated bed is causing some interfernce with the mesh and for the 30 - 40seconds it takes to scan the bed it wont make a huge difference from a heat point of view
1 replies
RRCRat Rig Community [Unofficial]
•Created by Quinny on 6/15/2023 in #fix-my-printer
Section 'ratos_homing' is not a valid config section
39 replies
RRCRat Rig Community [Unofficial]
•Created by Quinny on 5/9/2023 in #fix-my-print
Cant get a consistent first layer
14 replies
RRCRat Rig Community [Unofficial]
•Created by Quinny on 4/30/2023 in #fix-my-printer
X/Y axis not even
6 replies
RRCRat Rig Community [Unofficial]
•Created by Quinny on 4/20/2023 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
Hi All,
Board: Manta M8P v1.1
Getting unable to read tmc uart 'stepper_z' register ifcnt, I've checked that i've jumpered everything correctly and checked the pin out is correct in the config, i'm going to go over my wiring again and confirm all my crimps are good. Is there any other way i can test/narrow down what could be the cause? if its not wiring my only other thought is a DOA Board?
37 replies