Vaynexx_
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 2/12/2024 in #fix-my-printer
Printer stops while priming nozzle
Hey,
for some reason my VCore 3 300mm stops while doing the prime blob. It stops the second that the bed is supposed to go down and the printhead backwards. I havent changed the hardware or setup of the printer. It just stopped working a few days ago. The only thing that changed, is that i have a new pc, and a factory reset slicer. For the slicer setup I have copied the start gcode from the RatOS Setup page into orca slicer. But I dont think the gcode is the issue, since the identical gcode that has worked before, dosent work now. I am really confused and frustrated, and would be happy to get some help :/
3 replies
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 7/21/2023 in #fix-my-printer
Pi crashes when calibrating Input Shaper
I strapped a ADXL345 to the EVA3 and its correctly connected to the Octopus.
When I type in SHAPER_CALIBRATE the print head vibrates and does its thing.
When its done Vibrating and Calculating the Data the Pi freezes and just does nothing. I left it sitting for 30min and its just not doing anything. Is my Raspberry Pi 3A+ just not powerful enough? Is there anything I can do to let the printer calibrate itself?
When its done Vibrating and Calculating the Data the Pi freezes and just does nothing. I left it sitting for 30min and its just not doing anything. Is my Raspberry Pi 3A+ just not powerful enough? Is there anything I can do to let the printer calibrate itself?
4 replies
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 5/20/2023 in #ratos-support
MCU Error
Hey,
im setting up the software of my vcore3, and it seems like im not able to flash the correct firmeware on the Octopus v1.1. i have completed the FAQ steps, flashed the board without anything connected. Mainsail says, that Klipper dosent want to start, and some MCU error.
Ive included the logs of Klipper and Moonraker.
Am i supposed to put that jumper below the proccessor in or out? Im kinda confused at this point, ive tried to troubleshoot the whole day.
2 replies
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 5/20/2023 in #fix-my-printer
NIDEC Fan where do i plug it in?!?!
Hey, im setting up my Vcore3, and ordered this part colling fan:
4028 Axial - NIDEC W40S12BS2E5-57T04HF9 (12V 1.61A 25000RPM)
But where the heck do i plug that in? The diagram in the instructions shows i should plug it on my Octopus which has a completely different connector. The Fan has 4 Wires, while the connector has 2 wires.
The wiring kit I got did not have wires for supplying power to everything. Is that normal?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 5/20/2023 in #fix-my-printer
Octopus V1.1 was not detected
79 replies
RRCRat Rig Community [Unofficial]
•Created by Vaynexx_ on 5/18/2023 in #fix-my-printer
Issue with Belt
11 replies