guru-florida
RRCRat Rig Community [Unofficial]
•Created by guru-florida on 9/17/2024 in #fix-my-print
Burn-through in ASA? What causes this failure?
56 replies
RRCRat Rig Community [Unofficial]
•Created by guru-florida on 3/21/2024 in #fix-my-printer
I can’t PROBE_CALIBRATE. Clicking +0.1 results in the printer going down and back up by 0.1.
I can click that button until the cows come home but the bed will not get closer to the nozzle. The bed moves but immediately undoes the same move. The dashboard will reflect an overall change in Z so the “undo” so it seems position does get out of sync. If I use the 1mm button then the bed will get closer (or farther away) from the nozzle but I still see a 0.1mm reverse movement which should not happen IMO. I did this countless times easily on my last core so I’m not new to this command, but the UI is new, I just used TESTZ before.
Video shows me clicking 0.1mm once, the nozzle goes up and then down and rests at the original position.
I've already done homing, ztilt, belt and input shaping graphs with no motion issues so I don't believe it's a wiring/controller issue.
7 replies