Silver Raider US
RRCRat Rig Community [Unofficial]
•Created by Silver Raider US on 1/11/2024 in #fix-my-printer
4028 running at 100% at 1-100
So I just upgraded my bearings to ceramic, while doing those i also updated to the new toolhead beta2. I left my 4028 fan plugged in and did nothing to firmware, but now my fan only runs at 100 %. It is wired as said in ratrig using the bed heater as ground and i have the added fan part in user overrides to use pin PA3 for the heater, the blue wire back to ground on the original part cooling fan pin, and the positive to a always on pin. This is how it was before upgrade and worked fine, no idea on what else to check
8 replies
RRCRat Rig Community [Unofficial]
•Created by Silver Raider US on 7/15/2023 in #ratos-support
Beacon Help
Ok, so I have the Beacon installed and running to the PI , the red light comes on the board when triggered , I just don't know what to do in printer config or where to start as I don't see the Beacon as a option in printer config to be selected, just further in the Ratos file under z-probes, sorry don't know what I am doing on this one TIA!!!!
130 replies
RRCRat Rig Community [Unofficial]
•Created by Silver Raider US on 2/7/2023 in #fix-my-print
Pot holes on surface
20 replies
RRCRat Rig Community [Unofficial]
•Created by Silver Raider US on 12/23/2022 in #fix-my-printer
Bed size
Ok where should I ask, I took away the # in front of the 400 in print config and put it in front of the 300 and yet the z tilt still acts like its a 300 , what did I not do ?
41 replies