pd
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
yeah based on one of my cnc router via wincnc there is a setting called "smoothing" that has a large effect on artifacts like this and i wondered if there is an equivalent via ratos or prusa settings
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
for the longest time, i thought the round corners were a result of the circular nozzle, as you said. that is, until i tried it on the ender 6 and the corners were much, much sharper
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
i will play with the jerk settings
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
i've actually gone down to 0.1 corner velocity and it made no difference whatsoever. keep in mind the ender 6 pictured has a 0.6mm nozzle same as the ratrig
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
i have, yes
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
PA?
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
Something very frustrating about this problem is it doesn't seem to matter what speed/accel the machine is set to, the corners will get rounded. I've gone as low as 20mm/s and under 1000mm/s^2 and it has made absolutely zero difference with how the corners are rounded.
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 12/21/2023 in #ratos-support
Retries aborting: Probed points range is increasing.
yep. Thank you!
5 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 12/21/2023 in #ratos-support
Retries aborting: Probed points range is increasing.
Please disregard or delete this post. I had the Z wires mismatched
5 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 12/21/2023 in #ratos-support
Retries aborting: Probed points range is increasing.
I do not see any obvious mechanical issues. When doing manual movements, all 3 lead screws and couplers spin perfectly fine. The probe is firmly in place.
5 replies