pd
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 12/21/2023 in #ratos-support
Retries aborting: Probed points range is increasing.
Still doing the initial config and setup and getting this error when trying to home the Z tilt. I verified that all 3 steppers are moving in the correct direction using "SET_CENTER_KINEMATIC_POSITION" and moving the bed up and down.
5 replies