Retries aborting: Probed points range is increasing.
Still doing the initial config and setup and getting this error when trying to home the Z tilt. I verified that all 3 steppers are moving in the correct direction using "SET_CENTER_KINEMATIC_POSITION" and moving the bed up and down.
3 Replies
generous-apricotOP•14mo ago
I do not see any obvious mechanical issues. When doing manual movements, all 3 lead screws and couplers spin perfectly fine. The probe is firmly in place.
Please disregard or delete this post. I had the Z wires mismatched
The order of your Z motors is wrong
generous-apricotOP•14mo ago
yep. Thank you!