3DBIM-Solutions

PostsComments

RRCRat Rig Community [Unofficial]

•Created by 3DBIM-Solutions on 1/2/2025 in #fix-my-printer

When homing z the probe doesnt trigger and rams the hotend in the bed

I am finalising the my vcore3.1 ratos 2.1 rc3 with ebb42 and 8mm npn-no probe. At first my homing, ztilt and bed mesh went fine. After bed and hotend pid tuning I wanted to set the nozzle offset. From this point everytime I home z the hotend rams into the bed twisting the gantry. Ik looks like it doesnt trigger, but when I manually hold something iron to it when homing z it triggers. Also when I manual level the bed and check the endstops it also says its triggered. Cant understand why while homing this suddenly doesnt trigger anymore. Any ideas?

23 replies

RRCRat Rig Community [Unofficial]

•Created by 3DBIM-Solutions on 12/30/2024 in #ratos-support

Existing command TEST_RESONANCES not found in RatOS override

11 replies