Alexander Wiltschek
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
maybe i can add my adlx.cfg later and remark it when i am not using it
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
thats bad to hear. so only way is to reconfigure it and remove adxl in the configurator.
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
i am not sure (switched off allready) if i see config issue when i pull the usb-adxl off my pi.
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
is there a way to easily disable a usb-adxl as i dont have it all the time mounted on my print head.
need to implementing EBB42 (new printhead switch to EVA3 on my VC3) then this should be fixed (as its part of the board)
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/31/2024 in #ratos-support
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
no clue where i can attach the debug.zip but in case mikl wants to fix this issue for V3 500 here it is
33 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/9/2024 in #fix-my-mesh
Some tips i found by researching on my own and watching the video ratrig how to get a square frame
also loosen the top screws from the motormount which are connected to the frame a bit so you remove tension on your frame and of course your frame should be excellent but too much tension costed my 0.3mm
4 replies
RRCRat Rig Community [Unofficial]
•Created by Alexander Wiltschek on 12/9/2024 in #fix-my-mesh
Some tips i found by researching on my own and watching the video ratrig how to get a square frame
it also helped to loosen the screws from the linear rail on the gentry and carefully fix them from one side to the other - not too hard
4 replies
RRCRat Rig Community [Unofficial]
•Created by Flo@GRNbms on 12/7/2024 in #fix-my-printer
Heightmap problem
loosen all screws on the linear rail on the gantry and fasten them from one side to the other - then lool again
5 replies