Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
After setup of RatOS v2.1.0-RC3-21-g31ad483fand selection of my boards including the correct X/Y accelarometer (connected to Host) i still get this error message.
This still comes when i try to comment all sections referencing to the accelarometer.
I have a VCore 3 500
Solution:
Jump to solution
its crazy. after 4 full setup retries it now worked !
What did i do.
New Image, Update RatOS, Reboot, Refresh Update Manager, Update Configurator, Reboot, Refresh Update Manager, Update the rest. Whats confusing me a bit is that the Update Manager no longer shows RatOS in the list ?!
Is this correct ?...
28 Replies
no clue where i can attach the debug.zip but in case mikl wants to fix this issue for V3 500 here it is
reboot, refresh updates, update all
Solution
its crazy. after 4 full setup retries it now worked !
What did i do.
New Image, Update RatOS, Reboot, Refresh Update Manager, Update Configurator, Reboot, Refresh Update Manager, Update the rest. Whats confusing me a bit is that the Update Manager no longer shows RatOS in the list ?!
Is this correct ?
that's because ratos and the configurator have merged https://discord.com/channels/582187371529764864/844364874216898562/1319098058016821349
is there a way to easily disable a usb-adxl as i dont have it all the time mounted on my print head.
need to implementing EBB42 (new printhead switch to EVA3 on my VC3) then this should be fixed (as its part of the board)
what do you mean by disable it?
i am not sure (switched off allready) if i see config issue when i pull the usb-adxl off my pi.
with normal klipper you cant disconnect MCUs when its turned on, thats normal
this works ony with kalico
thats bad to hear. so only way is to reconfigure it and remove adxl in the configurator.
unfortunately yes
maybe i can add my adlx.cfg later and remark it when i am not using it
this works as well
After update of everything, my camera is not showing anymore in mainsail, and shows Connecting to http://xxxxxxxxxxxxx/webcam/?action=stream, but if I paste this link in to the new tab then I can see the stream from camera, any idea how to fix this?
Open your own thread please.
im not a big help with webcams, sorry
Yes, ive accidently send it to wrong section. Alredy fixed!
Hi, I have the same error after "updating" all the config files. And a bit more, photo attached. What am I missing?
and this one now..
@miklschmidt any ideas? 😦
Never mind, it fixed itself.... 😄 I just pressed soft recovery and restarted the printer. Now 0 errors.
Try a hard refresh (ctrl+shift+r) on the browser, refresh updates and update of needed.
Or, you can go directly ssh and send
ratos doctor
BTW, any of the resets is a no no. Either soft or hard. It can mess everything
okay, I hope it didn't mess up anything... 😄
indeed hard reset on the configurator repository and then ssh into the pi and run
ratos doctor. That should get you going.a mi me pasa lo mismo actualizo y nada me sigue igual
aqui se hablan ingles
ok
#spanish
solution above...