DZisky
RRCRat Rig Community [Unofficial]
•Created by DZisky on 1/10/2025 in #ratos-support
RatOS invalid recovery fails
4 replies
RRCRat Rig Community [Unofficial]
•Created by DZisky on 11/17/2024 in #ratos-support
webcam stream not found
37 replies
RRCRat Rig Community [Unofficial]
•Created by DZisky on 11/17/2024 in #ratos-support
(vaoc) webcam stream not found
I get an error as in title when I go to VAOC tab in UI. I added (and double checked) the config to crowsnest.cfg as per "Step 4 - Configure the VAOC camera [mandatory]" from the guide. When I check crowsnest logs then it seems like it's finding the camera:
INFO: Found 1 total available Device(s)
[11/16/24 08:17:16] crowsnest: INFO: Found 1 available v4l2 (UVC) camera(s)
[11/16/24 08:17:16] crowsnest: /dev/v4l/by-id/usb-3DO_Rat_Rig_VAOC_Camera_3DO-video-index0 -> /dev/video0
but at the end of the logs is says:
[11/16/24 08:17:17] crowsnest: Try to start configured Cams / Services...
[11/16/24 08:17:24] crowsnest: INFO: Configuration of Section [cam 1] looks good. Continue ...
[11/16/24 08:17:24] crowsnest: WARN: Mode 'camera-streamer' is not supported on your device!
[11/16/24 08:17:24] crowsnest: WARN: Falling back to Mode 'ustreamer'
[11/16/24 08:17:27] crowsnest: V4L2 Control: No parameters set for [cam 1]. Skipped.
[11/16/24 08:17:32] crowsnest: Starting ustreamer with Device /dev/video0 ...
[11/16/24 08:17:34] crowsnest: ... Done!
So it complains that "camera-streamer" is not supported (and this mode is what guide says to put in the config) and it fallbacks to ustreamer which then apparently works. I tried changing "camera-streamer" to "ustreamer" in config but then VAOC tab still shows error.
4 replies
RRCRat Rig Community [Unofficial]
•Created by DZisky on 11/15/2024 in #ratos-support
unable to open out gpio chip line
New installation of latest RatOS 2.1 on Manta M8P V2.0 with CB1 on VC4 IDEX, all components updated to laters version. Klipper doesn't boot, throws error:
MCU 'rpi' error during config: Unable to open out GPIO chip line
17 replies
RRCRat Rig Community [Unofficial]
•Created by DZisky on 7/9/2024 in #fix-my-print
New VC4 prints awful
6 replies
RRCRat Rig Community [Unofficial]
•Created by DZisky on 7/4/2024 in #fix-my-resonance
Can't get good graphs on VC4 400
10 replies