Yucca
RRCRat Rig Community [Unofficial]
•Created by Tornillo on 10/18/2024 in #fix-my-print
Underextrusion issue - Vcore 3.1
What extruder you have? I just had simmilar issue and it was LGX lite that did not push filament consistently, I switched to Orbiter v2 and all perfect
4 replies
RRCRat Rig Community [Unofficial]
•Created by Yucca on 12/15/2024 in #fix-my-print
PLA cracking on Minion but flawless on Vcore3
in the end it was extruder LGX lite, its crap design with finite tension, it was not tight enough in the middle position. solution swith to orbiter
7 replies
RRCRat Rig Community [Unofficial]
•Created by Yucca on 12/15/2024 in #fix-my-print
PLA cracking on Minion but flawless on Vcore3
nobody any clue?
7 replies
RRCRat Rig Community [Unofficial]
•Created by deep-jade on 2/20/2023 in #fix-my-mesh
First Layer problem, always squished on bottom left/ left side
Hi, I have same problem, posted a few days back. no answer, no solution...
37 replies
RRCRat Rig Community [Unofficial]
•Created by Chrizzar on 1/19/2023 in #fix-my-mesh
Corner dip. Bed level with PAM. Uneven first layer. i.e. perfect layer one side, opposite too close
hi any solution to this? have the same problem as previous post...
20 replies