PLA cracking on Minion but flawless on Vcore3
Hi, sliced in orca for both printers with same setting for both. both printers has same extruder and hotend. I have tried on minion higher Temp, more and less cooling. more shells. I`m out of ideas what causing this ( same Filament same spool) (prints on right side of foto are minion )
Solution:Jump to solution
in the end it was extruder LGX lite, its crap design with finite tension, it was not tight enough in the middle position. solution swith to orbiter
4 Replies
nobody any clue?
Looks like you are struggling with layer adhesion. Do either of your printers happen to use a rapido 2? Apparently they had a bad batch where the thermistors are approximately 20 degrees off.
To exclude the faulty thermistor, switch the extruders.
If the problem moves to the vcore, then it's definitely the bad batch problem.
Solution
in the end it was extruder LGX lite, its crap design with finite tension, it was not tight enough in the middle position. solution swith to orbiter