jhorn68 (V-Core 3.1 400) Posts

jhorn68 (V-Core 3.1 400)

•Created by jhorn68 (V-Core 3.1 400) on 6/7/2024 in #ratos-support

Error evaluating 'gcode_macro START_PRINT:gcode': gcode.CommandError: Filament not detected! Toolhea

I tried to configure the Orbiter Filament Sensor using the below in printer.cfg and anytime I print I get this error. [filament_switch_sensor toolhead_filament_sensor_t0] pause_on_runout: False event_delay: 0.1 switch_pin: ^!toolboard_t0:PB3 runout_gcode: _ON_TOOLHEAD_FILAMENT_SENSOR_RUNOUT TOOLHEAD=0 insert_gcode: _ON_TOOLHEAD_FILAMENT_SENSOR_INSERT TOOLHEAD=0 [gcode_button toolhead_filament_sensor_button_t0] pin: ^!toolboard_t0:PB4 release_gcode:
_ON_FILAMENT_SENSOR_BUTTON_PRESSED TOOLHEAD=0 press_gcode: #[include OrbiterSensor.cfg] BTW, removing the negation on the switch_pin seems to work.

30 replies

RRCRat Rig Community [Unofficial]

•Created by jhorn68 (V-Core 3.1 400) on 6/4/2024 in #ratos-support

Where would these settings come from in RatOS.cfg?

I did a comparison of my config from 2.0 to 2.1. I can't figure out where this change originated. max_z_velocity: 50 max_z_accel: 600

8 replies

RRCRat Rig Community [Unofficial]

•Created by jhorn68 (V-Core 3.1 400) on 6/4/2024 in #ratos-support

Maybe I am doing something wrong, but 2.1 homing scratched the hell out of my build plate