Maybe I am doing something wrong, but 2.1 homing scratched the hell out of my build plate
So it seems that I got myself in a little pickle. The X and Y homing procedure raises the bed for some reason, it did this both on X and Y. You can't run BEACON_CALIBRATE without homing X and Y, but if your bed is too high when you try and home them it will push the bed into the nozzle then scratch the hell out of your bed plate. I didn't have an issue at all getting any of this set up in 2.0, so I wasn't ready with the emergency stop.
4 Replies
You have your x motors reversed
Well, I figure that out by looking at the old printer.cfg. Now my biggest issue is getting the bed flat enough to do BEACON_CONFIG without running the bed arms into the top lead screw supports since I had to manually lower the bed. This was much more straightforward with a physical probe.
My mistake, still annoyed..
It's ok, I went to shorten the left over belt on my tool head and accidentally cut the main belt instead the first time I was putting my printer together
Hopefully I didn't mess up the CHT nozzle thats on there too. Oh well, live and learn