vinnyvin_98
RRCRat Rig Community [Unofficial]
•Created by vinnyvin_98 on 2/19/2024 in #fix-my-resonance
How can I improve?
3 replies
RRCRat Rig Community [Unofficial]
•Created by vinnyvin_98 on 6/16/2023 in #fix-my-print
Option 'retract_length' is not valid in section 'extruder'
Really not sure what happened here. I did not use the printer for a couple of days. Went to go start a print and the following error appeared. I checked my printer.cfg file and nothing had changed with that value.
Here is the full message: "Option 'retract_length' is not valid in section 'extruder'
Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted"
2 replies
RRCRat Rig Community [Unofficial]
•Created by vinnyvin_98 on 4/28/2023 in #ratos-support
Pin '4p_fan_part_cooling_tach_pin' is not a valid pin name on mcu 'mcu'
Please help.
.cfg attached
14 replies
RRCRat Rig Community [Unofficial]
•Created by vinnyvin_98 on 4/1/2023 in #fix-my-printer
Is my bed mesh enabled?
I am wondering if I somehow disabled the bed mesh on my 3.1 500mm printer. Just seems like I am getting uneven layer adhesion and I am not sure if I messed something up in my configuration by accident...does somebody mind taking a look at my printer.cfg?
2 replies
RRCRat Rig Community [Unofficial]
•Created by vinnyvin_98 on 1/15/2023 in #fix-my-printer
Bed not heating
26 replies