Yannic
RRCRat Rig Community [Unofficial]
•Created by Yannic on 3/4/2025 in #ratos-support
Shutdown when connecting webcam
Hello,
I tried to connect a Logitech C270 Webcam to my printer. I phisically conectet the Webcam via USB. Now Klipper shuts down and stays down. I tried restarting but the problem doesnt disapear. And klipper reports ERROR.
I have attached the log files. So maby someone can troubleshoot my problem.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Yannic on 6/8/2024 in #ratos-support
Moonraker Update fails
22 replies
RRCRat Rig Community [Unofficial]
•Created by Yannic on 8/21/2023 in #fix-my-mesh
Z- TILT doesnt work correctly
12 replies
RRCRat Rig Community [Unofficial]
•Created by Yannic on 8/17/2023 in #ratos-support
4028 fan speed control reversed
I have encountered a problem with my 4028 fan. The fact that the fan runs at 100% after boot up is known to me. The problem is that the fan only goes off when I set the fan speed to 100%. If I set the fan speed to 0%, the fan runs at full speed. This makes me think that it is reversed. Can I change this in the software or is this a hardware error in my wiring?
17 replies