letniq
RRCRat Rig Community [Unofficial]
•Created by letniq on 1/21/2025 in #ratos-support
DC slammed on Homing after Set Kinetic Centre
If you set kinetic center and then try to Home, the T0 will home fine however DC will get slammed at the end stop. The only way to avoid this is to restart firmware.
VCore4 300mm nothing crazy in the config.
10 replies
RRCRat Rig Community [Unofficial]
•Created by letniq on 11/1/2024 in #ratos-support
IDEX Misses Z moves
8 replies
RRCRat Rig Community [Unofficial]
•Created by letniq on 10/27/2024 in #ratos-support
IDEX Offset Manual setup
Is there a way to apply the offset inside ratos-variables manually. VAOC module was a complete disaster so far for me.
There is a varible idex_applied_offset = 0 which I believe is like boolean whether to apply the offsets but it is 1 only when try to calibrate via VAOC module. Is there a way to force RatOS to use the offsets (idex_xoffset , idex_yoffset, idex_zoffset ) inside this file without the VAOC module.
118 replies
RRCRat Rig Community [Unofficial]
•Created by letniq on 10/27/2024 in #ratos-support
VAOC Set Reference and Set Offset missing
I managed to get my camera going and tried to calibrate the offsets with VAOC. However on the videos that I watched there were set reference and set offset buttons. Are there any further steps that I need to do before they apear or the videos are from older version and the VAOC is setting these automatically. I'm having a toolhead thermal calibration button on the place the set ref and set offset apear on the videos?
https://github.com/VisualTech48/RatOS/blob/patch-1/site/docs/VAOC.md
4 replies
RRCRat Rig Community [Unofficial]
•Created by letniq on 10/26/2024 in #ratos-support
IDEX Configuration Motor Conflict Dual Carriage and Y1
8 replies