solmaelstrom
RRCRat Rig Community [Unofficial]
•Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
I kind of never did check the bed before adding the magnetic bed and flex pei sheet so I am kind of a little in the dark as to what my issue is.
18 replies
RRCRat Rig Community [Unofficial]
•Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
I look forward to seeing if you fix your problem Jasmin for i haven't fixed mine yet I've accepted it for now and just started printing.
18 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/10/2024 in #fix-my-mesh
hump In bed (V Core 4 500mm)
Thanks Doc I'll look into it
21 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Thanks for the help prav
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Wait you said the wire loom pulling on the axis hmm
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Great as for the z bump on the x axis any ideas?
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
So for a standard @Prav the y acceleration is about 3300?
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Plus the atrocious wiring I'd like to confirm if cable routing would improve the y axis metrics out of sight as the x axis speeds look great
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Attached are the shaper graphs and belt tension graphs
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/10/2024 in #fix-my-mesh
hump In bed (V Core 4 500mm)
Sorry what do you mean by textured grain do you mean under the magnetic bed @DocDoyle
21 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/10/2024 in #fix-my-mesh
hump In bed (V Core 4 500mm)
There was a bend but that wasn't the problem
21 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/10/2024 in #fix-my-mesh
hump In bed (V Core 4 500mm)
not the hump though
21 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/10/2024 in #fix-my-mesh
hump In bed (V Core 4 500mm)
X gantry extrusion had a bend
21 replies