hump In bed (V Core 4 500mm)

Is this a bow in my magnetic sheet or something sort of squaring issue? Or something else entirely let me know if I can flatten this by making some adjustments please
No description
No description
7 Replies
VisualTech48
VisualTech485mo ago
This is most likely an X gantry issue But can't see as your images are not full. I need the right side as well. Generally, you want to start fixing this by tightening the whoel X gantry from left to right the same. If that doesn't work out, You can pull UPWARDS you X gantry where the red peak is With your hand You always have to imagine your bedmesh backwards, as in, the Nozzle is Closer at the Red points, not that it goes higher at the Red points But first fix you X gantry, with the pull or retightening the bolts Then do the Z again, Z-Tilt, then Bed mesh Come back with the result.
solmaelstrom
solmaelstromOP5mo ago
X gantry extrusion had a bend not the hump though There was a bend but that wasn't the problem
VisualTech48
VisualTech485mo ago
Share more, otherwise I cannot help. Send your bed mesh and lets go again.
DocDoyle
DocDoyle5mo ago
i had this and there was a line of some of the textured grain on the bottom. perhaps something else underneath?
solmaelstrom
solmaelstromOP5mo ago
Sorry what do you mean by textured grain do you mean under the magnetic bed @DocDoyle
DocDoyle
DocDoyle5mo ago
some of the stuff that sits on top of the flex steel plate was scattered on the bottom as well causing bumps in my bed mesh
solmaelstrom
solmaelstromOP5mo ago
Thanks Doc I'll look into it
Want results from more Discord servers?
Add your server