Sören Comments - Answer Overflow

Sören

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by venki on 11/16/2024 in #ratos-support

Ebb42 not connecting tried following the step but doesn't connected

nope the VBUS is between USB and Power connector and is bridged in the picture

8 replies

RRCRat Rig Community [Unofficial]

•Created by WrinklySackNick on 10/12/2024 in #fix-my-printer

Printer crashes when heating bed

Can you post your klippy.log file?

4 replies

RRCRat Rig Community [Unofficial]

•Created by Rigattoni on 9/26/2024 in #german-support

END_PRINT und Folge-G-Code vertragen sich nicht.

[gcode_macro POWER_OFF_PRINTER]
gcode:
  {action_call_remote_method("set_device_power", device="printer", state="off")}

[idle_timeout]
timeout: 1200
gcode:
  M84
  TURN_OFF_HEATERS
  UPDATE_DELAYED_GCODE ID=delayed_printer_off DURATION=60

[delayed_gcode delayed_printer_off]
initial_duration: 0
gcode:
  {% if printer.idle_timeout.state == "Idle" %}
    POWER_OFF_PRINTER
  {% endif %}

[gcode_macro POWER_OFF_PRINTER]
gcode:
  {action_call_remote_method("set_device_power", device="printer", state="off")}

[idle_timeout]
timeout: 1200
gcode:
  M84
  TURN_OFF_HEATERS
  UPDATE_DELAYED_GCODE ID=delayed_printer_off DURATION=60

[delayed_gcode delayed_printer_off]
initial_duration: 0
gcode:
  {% if printer.idle_timeout.state == "Idle" %}
    POWER_OFF_PRINTER
  {% endif %}

https://www.klipper3d.org/Config_Reference.html?h=idle#idle_timeout

6 replies

RRCRat Rig Community [Unofficial]

•Created by Rigattoni on 9/26/2024 in #german-support

END_PRINT und Folge-G-Code vertragen sich nicht.

das power off printer now ist ja noch teil des Druckauftrags. also erst mit runterfahren ist der zu 100% fertig. Bei mir hab ich ein Idle Timeout drin. wenn der 15min unter einer bestimmten temp ist, dann schaltet der ab. Das kam irgendwie auch zum teil aus Ratos wenn ich mich richtig errinnere (hatte ich zum ersten mal bei mir mit dem Ender 3 gemacht)

6 replies

RRCRat Rig Community [Unofficial]

•Created by TUDO3D on 9/19/2024 in #ratos-support

Connection via CANawa

a powered USB hub could be the solution

20 replies

RRCRat Rig Community [Unofficial]

•Created by TUDO3D on 9/19/2024 in #ratos-support

Connection via CANawa

The RatOS features like the macros and such should work for can davices,if the MCU is configured correctly. just the easy installation via the configurator is not possible

20 replies

RRCRat Rig Community [Unofficial]

•Created by Sören on 9/15/2024 in #fix-my-printer

Huge Layershift

testing atm with a lower speed, looks good so far.

8 replies

RRCRat Rig Community [Unofficial]

•Created by Sören on 9/15/2024 in #fix-my-printer

Huge Layershift

i know but there was something said in the background that required me to mute it.

8 replies

RRCRat Rig Community [Unofficial]