Simon
RRCRat Rig Community [Unofficial]
•Created by Simon on 4/1/2025 in #ratos-support
VAOC webcam stream not found
Everything is working now! I reinstalled RatOS and went through the entire setup from scratch.
3 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/18/2025 in #fix-my-print
3 good layers then no succesful print
I got news! First successful benchy is printed. The original belts had some give to them. I cant explayn why. I put new ones in and now it is working!
16 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/18/2025 in #fix-my-print
3 good layers then no succesful print
16 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/18/2025 in #fix-my-print
3 good layers then no succesful print
16 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/18/2025 in #fix-my-print
3 good layers then no succesful print
However I have bad layershifts after some layers. I am trying to get the belts right but it is not working for me. I looked if they are not the same length and tried to tention them several times. But alwais those layer shifts. I think my frame is slightly twisted but when I align the gantry in the back so there is no play, I have play in the front. I have a belt tention graph that as far as I can tell is ok. Maby somebody can help me
16 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/18/2025 in #fix-my-print
3 good layers then no succesful print
Sorry for the late answer from my side. It is extruding nicely now. The problem was the standard nozzle. I never crashed into the bed or similar. I baught a new one and it extrudes perfectly fine now.
16 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/14/2025 in #fix-my-printer
Beacon Probe initial Calibration
Ok thank you
14 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/14/2025 in #fix-my-printer
Beacon Probe initial Calibration
But then the Bed moves in the wrong direction. When i klick the arrow up it would move down
14 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/14/2025 in #fix-my-printer
Beacon Probe initial Calibration
Thank you
14 replies
RRCRat Rig Community [Unofficial]
•Created by Simon on 2/14/2025 in #fix-my-printer
Beacon Probe initial Calibration
Sorry but where can i find the debug.zip?
14 replies