CeredD#77

PostsComments

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 7/22/2024 in #ratos-support

Move exceeds maximum extrusion

3 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 5/28/2024 in #german-support

Heater_Bed not heating at expected rate

13 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 5/28/2024 in #fix-my-printer

Heater_Bed Not Heating at expected rate

29 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 12/15/2023 in #fix-my-printer

4028 Controller Fan running at 100% after Homing

Hello, my Controller Fan is running at 100% after Homing, any ideas how i can fix that?

12 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 12/15/2023 in #german-support

4028 Controller Fan läuft auf 100%

Hab das Problem das der Lüfter auf 100% Läuft sobald das Hotend aufgeheizt wird.

16 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 8/13/2023 in #german-support

V Minion Sensorless homing

7 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 6/11/2023 in #ratos-support

How to change the Fan Pin in the Printer.cfg ?

I want to change the PIN assignment from the hotend to the build fan how would this look like?

9 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 6/5/2023 in #german-support

Part Cooling Fan dauerhaft aktiv

Seit neuestem ist bei meinem Minion der Lüfter für die Bauteil Kühlung dauerhaft aktiv. Ich konnte leider nichts in den Channels dazu finden. Einen neuen Lüfter hatte ich auch schon angeschlossen. Und da liegt das selbe Problem vor.

17 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 5/28/2023 in #fix-my-printer

Goliath Hotend may extrusion

3 replies

RRCRat Rig Community [Unofficial]

•Created by CeredD#77 on 1/3/2023 in #german-support

4028 Lüfter geht nicht aus bei 0%

Ich habe den 4028 Lüfter Sanyo Denky s001 verbaut und dies in die config eingefügt. [fan] pin: !fan_part_cooling_pin cycle_time: 0.01 enable_pin: PA9 Trotzdem dreht der Lüfter mit einer niedrigen Drehzahl

93 replies