GhostHands
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 3/11/2024 in #fix-my-printer
Layer shifts
Printer that works fine for months suddenly starts layer shifting on me.
What are some things to check while I have this thing apart?
What are some things to check while I have this thing apart?
6 replies
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 9/8/2023 in #ratos-support
Update manager shows several "Invalid"
3 replies
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 7/11/2023 in #ratos-support
How can I make the primeline longer?
I would like to have a longer primeline.
2 replies
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 7/6/2023 in #fix-my-printer
TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
I looked around and it seems the motor driver is losing power? I tried swapping the extruder driver with the other drivers(I tried 3 different drivers) and I'm still getting the issue.
What else should I be looking at? Power supply? The motor itself?
Printer had previously been working, this is a new issue.
2 replies
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 4/30/2023 in #ratos-support
I updated RatOS and now I'm getting "Klipper configuration file not located in 'config' folder.
As the title says.
It's been about 6 months since I've used the printer. Turned it on and everything was working fine. Decided to hit the update all option and now it is giving me the following Moonraker warning:
file_manager: Klipper configuration file not located in 'config' folder.
Klipper Config Path: /home/pi/klipper_config/printer.cfg
Config Folder: /home/pi/printer_data/config
When I go into the machine tab, all the config files that are normally there are gone.
3 replies
RRCRat Rig Community [Unofficial]
•Created by GhostHands on 1/5/2023 in #fix-my-print
What setting is causing these fat perimeter overhangs?
5 replies