FredrikL
RRCRat Rig Community [Unofficial]
•Created by FredrikL on 1/5/2025 in #fix-my-printer
Z-Tilt Issue
Hello everyone!
I'm running Z-Tilt adjustment on my 3D printer, I have two steppers in the front and 1 in the back. (CoreXY for XY).
After Z-Tilt is done, if I start a print that goes form the from to the back, the rear half will be too far from the bed and the front half too close, I always end up "manually" moving the rear stepper up 1 step, and the front 2 steppers down one step each.
Basically; Z-Tilt gets kind of close, but consistently exactly the same "offset/error".
Probing points and stepper location points are spot on and rety tolerance is really fine, (0.01)
Any ideas?
7 replies
RRCRat Rig Community [Unofficial]
•Created by FredrikL on 10/24/2024 in #ratos-support
VAOC Stuck on loading
47 replies
RRCRat Rig Community [Unofficial]
•Created by FredrikL on 10/19/2024 in #ratos-support
Kinematics config/dependencies
11 replies
RRCRat Rig Community [Unofficial]
•Created by FredrikL on 8/2/2024 in #ratos-support
Step/Dir Drivers
Hi!
One of my TMC5160HV modules came broken out of the box, is there any way to make RatOS run using drivers that just take step/dir, in the meantime?
I cannot find a way to ask for this in the configurator.
10 replies
RRCRat Rig Community [Unofficial]
•Created by FredrikL on 7/6/2024 in #ratos-support
Hotend fan temperature control
18 replies