McNik
RRCRat Rig Community [Unofficial]
•Created by McNik on 12/26/2023 in #ratos-support
Beacon Y-Offset out of bounds
I just got my Beacon working despite some problems,
but when I try do do a bed besh, he always complains about an Out-Of-Bounds move in the front.
This is correct, since the Y-Offset would need him to go below the minimum Y=0.
How can I tell him to ignore the first few cm of the bed during meshing?
Funny thing is I am using the stock ratOS y-offset for the beacon which is pretty close to the real offset.
16 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 12/20/2023 in #fix-my-printer
Klipper shutdown when moving steppers
4 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 12/17/2023 in #ratos-support
ADXL-Pin errors
20 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 11/19/2023 in #fix-my-print
Extruder not working in specific corner.
4 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 11/4/2023 in #ratos-support
Files missing
8 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 2/22/2023 in #ratos-support
Trouble setting up sensorless homing
I am currently trying to setup the skr pico for RatOS on my new Voron 0.2, which uses sensorless homing.
I checked for correct jumper placement and know that the macros from ratos work since (due to a small mistake) I already saw them work before on this printer. But now that everything is checked, the drivers don't trigger, even at max sensitivity 255.
I attached my klipper log.
77 replies
RRCRat Rig Community [Unofficial]
•Created by McNik on 2/15/2023 in #fix-my-print
Strange Stringing on outside of print.
25 replies