El Pollo Macho
RRCRat Rig Community [Unofficial]
•Created by El Pollo Macho on 12/12/2024 in #ratos-support
Clean RatOS 2.1 install, Error after update
I'm getting the following Klipper error on a clean install:
Internal error during connect: module 'extras.resonance_tester' has no attribute 'VibrationPulseTest'
Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted
Do I need to downgrade my klipper, is something missing from RatOS?
9 replies
RRCRat Rig Community [Unofficial]
•Created by El Pollo Macho on 7/26/2024 in #fix-my-printer
4028 Fan Config, updating from VCore 3.1 to new Toolhead V1.0 with RatOS 2.1
I am reusing my old 4028 fan from a rig bought 2022, installing it into the new Toolhead V1.0, and upgrading my firmware to OS 2.1.
So far everything good, but I think my fan type does not work with the stock settings:
I have the Blue PWM pin connected to the EBB42 1.2 toolboard, and the power pins wired to the Octopus 1.1 board.
The problem I'm having is that the fan runs, but only when set to 100%, any other percentage and it stays off.
Normally not a huge issue, but the noise is making me lose my mind.
Thanks in advance!
17 replies