ziff7214
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 5/14/2024 in #ratos-support
RatOS Update Manager - all files show as corrupt
Hi,
Trying to run the updater and all of the files showed up as corrupt (with the message "repo is corrupt") and hard recovery isn't working. The printer seems fine (although the z probe fails occasionally for unknown reasons and the bed crashes into the nozzle) Is this a known issue or do I have to reflash something?
9 replies
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 8/28/2023 in #ratos-support
Section 'ratos_homing' is not a valid config section
Hi All,
Just got back to school from summer vacation and went through the update manager and now I'm getting the error "Section 'ratos_homing' is not a valid config section". I have changed nothing in the config file so I assume that means I was supposed to have? Could someone point me in the right direction here? Thanks! I have my config file attached if helpful.
26 replies
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 4/7/2023 in #fix-my-mesh
.7 on a 500, mostly in one corner
1 replies
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 4/4/2023 in #fix-my-printer
4028 fan issue after updating to ratos2
24 replies
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 3/28/2023 in #ratos-support
I think I broke moonraker. fix without starting from scratch?
I was trying to get klipperscreen working and I added authorizations to the moonraker config file, but then I couldn't get in via the web interface, so I tried to use portx to take out the changes I made but I think I modified/deleted the moonraker config file in a way that was unintentional. Can I force the system to put a new standard config file using the updated somehow? Not sure if this makes sense, but essentially I can only access the printer via portx right now
7 replies
RRCRat Rig Community [Unofficial]
•Created by ziff7214 on 3/28/2023 in #ratos-support
physical endstop always triggered
Hi, i broke one of my end stops and replaced it with a new one I got online but now the trigger is inverted. Where in the config do I find the "endstop_pin:" code to invert it (add a ! To before the port right?) ? Thanks!
6 replies