EEIN Comments - Answer Overflow

i have some printed crack sealers that rest flush against the seam between the aluminum frame and the acrylic panels, and i’ve sealed those seams again from the outside with some electrical tape

15 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 8/1/2024 in #fix-my-print

worbling on layer 2 (ASA)

i’m replacing the gantry and rebuilding the vent system this weekend. after that is setting up some filament drying. either an inline heater or just a big spool chamber. i do some small batch production so i’m always using 5kg spools

15 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 8/1/2024 in #fix-my-print

worbling on layer 2 (ASA)

i can’t get my enclosure above 70C or so since i have an exhaust fan venting out the styrene fumes & hot air

15 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 8/1/2024 in #fix-my-print

worbling on layer 2 (ASA)

i tried 40% and it looks a bit better. i was having warping and lifting issues before, but my bed was very very scuffed. i got a new bed plate and its adhesion is very very good, so i think it can handle the extra cooling

15 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 6/20/2024 in #fix-my-mesh

Vcore 500 mesh extreme cornering

Thanks!

60 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 6/20/2024 in #fix-my-mesh

Vcore 500 mesh extreme cornering

I'm considering buying a new CF or hollowed aluminum x gantry and a new x rail, but I don't be able to do that for a few weeks. I think the <0.250mm range I got yesterday should be good enough to work with for now

60 replies

RRCRat Rig Community [Unofficial]

•Created by EEIN on 6/20/2024 in #fix-my-mesh

Vcore 500 mesh extreme cornering

And it mentioned to tighten the X rail with as few nuts as possible, and only to about 1.5Nm. Mine are definitely wayyy tighter than that 😅

60 replies

Gaming

Programming