Votius
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/30/2025 in #ratos-support
Unable to parse 'inf' as a literal: malformed node or string:
2 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
Full rebuild of my v-minion, I only have data and 24v going to the tool head through my umbilical. Before i fire up ratos setup, is this wiring fine or should i use a usb cable to flash and then go back to my umbilical?
10 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 11/15/2024 in #fix-my-print
cleaner bridging and overhangs
2 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 9/3/2024 in #ratos-support
Supported board but unsupported printer
In the process of updating my V-Minion and was going to replace my old skr mini e3 v2 with a RatOS supported board. Both the M4P and Mini E3 V3 are supported, I'm guessing they are for the experimental Prusa support, but they are not supported boards for the V-Minion - https://os.ratrig.com/docs/printers/v-minion. They have more than enough ports, even more when using a tool head board. What's the best way to use one of those boards with the minion, or an unsupported board in ratos like the Pico or M5P? Its easy enough to to change the pin out for the printer.cfg, but what about the initial config of RatOS?
15 replies