Votius
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
all worked great
10 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
yep i have data +- usb, and then 24v +gnd through umbilical
10 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
first time ive used RatOS and now i need it for every printer............
10 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
And i just sent it at like 2am last night and that worked perfectly, all 3 boards flashed perfectly
10 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 1/25/2025 in #ratos-support
EBB42 flashing/setup via usb(data only) + 24v
data pins to usb port on pi through the NH36 portection board
10 replies
RRCRat Rig Community [Unofficial]
•Created by thinksimple on 7/16/2024 in #ratos-support
Nitehawk-36 Toolheadboard
they are starting to send out replacements
256 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 9/3/2024 in #ratos-support
Supported board but unsupported printer
any plans for ldo nitehawk 36 support at some point?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 9/3/2024 in #ratos-support
Supported board but unsupported printer
thanks
15 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 9/3/2024 in #ratos-support
Supported board but unsupported printer
Yeah sorry thats what I meant
15 replies
RRCRat Rig Community [Unofficial]
•Created by Votius on 9/3/2024 in #ratos-support
Supported board but unsupported printer
Thanks a lot! So if I go through the config and I'm using an unsupported board, would I just pick any board and update the printer.cfg after and then flash the board?
15 replies