Dave
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/21/2025 in #fix-my-printer
No VAOC Camera Image
Thank you for your reply. I will contact them!
5 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
I swapped the wireharness from T1 to T0 and now X (T0) is triggered so its the wire harness! Now any ideas on where I can get a new wireharness???
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
I agree. I swapped the tool board for a new one just to make sure it was not the cause. Unfortunately I don't have the connector supplies to rebuild the wire harness. I can swap the T0 wire harness to T1 and see if that helps.
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
yes
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
Yes, I have done that. The swith is fine and the wires are good
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
I believe NO
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
Yes, that give the status of the endstops. It is also shown on the "Machine" tab
14 replies
RRCRat Rig Community [Unofficial]
•Created by spacebaby0695 on 10/27/2024 in #fix-my-printer
Heater fault
is there a jumper that needs to be set? I checked the thermistor, it seems to be working. Apologies, I am a newbie.
12 replies
RRCRat Rig Community [Unofficial]
•Created by spacebaby0695 on 10/27/2024 in #fix-my-printer
Heater fault
Its a new build. I finished the configurator now trying to start Klipper
12 replies
RRCRat Rig Community [Unofficial]
•Created by spacebaby0695 on 10/27/2024 in #fix-my-printer
Heater fault
12 replies