Dave
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/21/2025 in #fix-my-printer
No VAOC Camera Image
I am commissioning my V Core 4 400 IDEX. At the "Initial VAOC Calibration" Step I select the "VAOC" tab but never get a video image only the spinning green circle. I did the _VAOC_RESET command and the M84 as specified. The Z Offset and the VAOC LED work properly.
Any help will be much appreciated.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Dave on 1/20/2025 in #fix-my-printer
Endstop dual_carriage still triggered after retract
14 replies