Umberto_21
RRCRat Rig Community [Unofficial]
•Created by NebuCHADnezzar on 4/2/2025 in #fix-my-resonance
IS Noob needs help with Y axis shaper :/
It looks quite ok, check klippain shake&tune guide, there is more information. Y axis is twice heavier than X, so its normal it is looking not as good as X
13 replies
RRCRat Rig Community [Unofficial]
•Created by Chris on 3/27/2025 in #ratos-support
unload macro moving out of range
it works to z offsets callibration, but when ik want to go out of VAOC calibration i cant and again move out of range
14 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 4/1/2025 in #ratos-support
VAOC calibration problems andc huge .zip files in config
@IDEXMAN
7 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 4/1/2025 in #ratos-support
VAOC calibration problems andc huge .zip files in config
another weird thing i noticet is that i have huge like 200MB file of config.zip that is create automativly, there were several of them in config section.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Chris on 3/27/2025 in #ratos-support
unload macro moving out of range
I have simillar problems i think with VAOC calibration, i tried to print in copy mode, something went wrong, i tried to SET_CENTER_KINEMATIC_POSITION and later G28, from this time j cant do anything and calibrate VAOC.
I will try M84
14 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 4/1/2025 in #ratos-support
VAOC calibration problems andc huge .zip files in config
7 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 4/1/2025 in #ratos-support
VAOC calibration problems andc huge .zip files in config
Im running klicky probe if it matters here, but it works fine
7 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 4/1/2025 in #ratos-support
VAOC calibration problems andc huge .zip files in config
Here are debugs from ratOS
7 replies
RRCRat Rig Community [Unofficial]
•Created by rmilyard on 2/19/2025 in #fix-my-printer
Odd isssue now trying to run VAOC
same thing here when calibrating VAOC.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 3/28/2025 in #fix-my-printer
Burned or Bricked raspberry 4b - no 3.3v
Update: After that kind of a reset i reinserted the SD card and it somehow start working so maybe rest of them are not bricked also but still look like weird OS stuff that blocking 3.3v so not good.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Umberto_21 on 3/28/2025 in #fix-my-printer
Burned or Bricked raspberry 4b - no 3.3v
Ok, weird thing. I pulled out MicroSD card and somehow 3.3V came up on LED status and on multimeter so can it be the system thing? On 3B+ works with no problem, on 4B+ i can get it stable.
4 replies