metal_mp
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/23/2025 in #fix-my-print
Non-ringing artifacts - what is it?
2 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/22/2025 in #ratos-support
Pause print nozzle temp
Is there any way to set the nozzle temp when the print is paused? I had some ABS burn in and clog the nozzle while the print got paused after a tangle detection while I was away for a couple of hours.
I guess a temp of 150c would be a bit safer than 260c I presume.
2 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/13/2025 in #fix-my-printer
Squeeky timing pulley
Hi, I've upgraded to IDEX and redone all the belts and re-tensioned everything. The timing pulley on the left X now makes a tiny squeeky noise for every full turn. I've narrowed it down to the set screws, if I untighten them, the squeeky sound is gone, so my only conclusion is that they somehow scrape over the motor shaft when moving... I've tried a lower belt tension but this doesn't seem to help a lot, only unscrewing the set screws.
So my question is actually: how important is it that these screws are set? I guess the pulley can now move a little with the belt, but is this a big issue? Lot's of belt wear or something?
12 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 1/21/2025 in #fix-my-resonance
Belt Tension check V-Core 4 400
2 replies