Jasmin
Jasmin
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
Thx - I got the hint here to ask at meltbro.de - they are able to send me a spare part 🙂 BTW - It´s hard to get parts for the Rapido 2 Plus - the guy at meltbro told me that the parts are ordered several weeks ago but still stuck in customs for 4 weeks now...
18 replies
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
I will test it when I got a new hotend after experience that the ceramic heater was broken. Sadly I found nowhere any spare parts for the Rapido2 escpecially no heater 😦
18 replies
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
My straightedge is only around 30 cm but if I place it on the buildplate and place a flashlight at one side, I can see a small gap at the read area visible on the heightmap. Yes you are right, I hadn´t install the magnet and heater after having seeing the first wave and I should have measure the plate before - my fault. I read somewhere that installing the magnet and PEI plate, the wave would be much lower - that is sadly not the case. So, I will go on with the current result and maybe replace the parts later if it´s really necessary because of really bad results in the first layer.
18 replies
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
No description
18 replies
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
No description
18 replies
RRCRat Rig Community [Unofficial]
Created by Jasmin on 7/16/2024 in #fix-my-mesh
Wave in bed (VC4-500)
I will give it a try to rotate the x-axis 3030 extrusions by 90° - if the axis is not in shape this might cause this issue - the problem is: it need time to do this... 😦
18 replies
RRCRat Rig Community [Unofficial]
Created by Synapsis on 7/15/2024 in #ratos-support
v2,1 Install problems.
I had the same issue writing a compressed image with balena etcher to sd-card on my Mac - I solved the issue by extracting the image first and was able to write the extracted image without any issue.
51 replies