ctbjdm_04135
RRCRat Rig Community [Unofficial]
•Created by ctbjdm_04135 on 12/4/2024 in #fix-my-printer
First prints, on the 2nd layer printer goes crazy
New VCore 500 Hybrid (but haven't installed the additional belts yet).
Motion seems fine - can Home, Z Tilt, toolhead moves as I direct it no problems.
Tried printing the first layer test in the commissioning guide; works fine.
Tried printing a Benchy (cause why not?) and first layer seems to be ok, but afterwards the toolhead moves erratically outside the footprint of the first layer, then it jerks to the front left of the bed, and might be dragging the nozzle on the bed as well.
I tried both PrusaSlicer and Orcaslicer, same thing.
Tried a different STL (angryratcam case, the front piece as it seems relatively simple) and same thing - first layer seems ok, after that it goes crazy and heads to the front left of the bed. New to 3d printing so perhaps I'm missing something obvious - would appreciate any help. Video: https://vimeo.com/1035812172/51f34a5fc9?share=copy
Tried a different STL (angryratcam case, the front piece as it seems relatively simple) and same thing - first layer seems ok, after that it goes crazy and heads to the front left of the bed. New to 3d printing so perhaps I'm missing something obvious - would appreciate any help. Video: https://vimeo.com/1035812172/51f34a5fc9?share=copy
6 replies
RRCRat Rig Community [Unofficial]
•Created by ctbjdm_04135 on 11/14/2024 in #fix-my-mesh
Wavy Vcore 4 500 mesh!
5 replies
RRCRat Rig Community [Unofficial]
•Created by ctbjdm_04135 on 11/8/2024 in #ratos-support
Unable to write tmc spi 'stepper_z' register GLOBALSCALER
428 replies