Oldschoolhippie
RRCRat Rig Community [Unofficial]
•Created by Oldschoolhippie on 10/5/2024 in #fix-my-resonance
VC4 500
5 replies
RRCRat Rig Community [Unofficial]
•Created by Oldschoolhippie on 9/23/2024 in #ratos-support
ADC out of range
Hello,
I have finished setting up my V Core 4 exactly according to the instructions.
As the title says, I have a problem with the following error:
MCU ‘toolboard_t0’ shutdown: ADC out of range
Sensor ‘extruder’ temperature 65707422.564 not in range 0.000:350.000
I have studied all the posts here in the Discord for quite a long time now and tried numerous suggestions, nothing helps.
When I measure the thermistor manually, I get a resistance of 1.089, so it should be OK. The jumper on the EBB42 is also set.
I have just re-crimped the cables and that didn't change anything either.
The correct thermistor is also stored in the config.
I'm at the end of my tether right now. I urgently need the printer. Hope you can help me
Greetings from Austria,
Daniel
55 replies