moskeeter407
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 2/18/2025 in #fix-my-printer
Y axis homing in wrong direction
the x axis homes in the right direction but the y axis goes towards the front. does anyone know why that would be?
62 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 2/13/2025 in #fix-my-printer
why would y axis only move an inch when homing to then say no trigger after full retraction
x axis homes fine but y moves an inch and stops to then say it got no trigger after moving only an inch and not even getting close to sensor
3 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 2/11/2025 in #ratos-support
homing
for some reason my printer will not home the Y axis. it moves an inch then stops. ive tried other drivers and wiring to no avail. any ideas would be appreciated
14 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 2/10/2025 in #ratos-support
i have an octopus pro 446 and it has some corrupt firmware on it
is there anyway to erase and install a fresh version?
96 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 11/21/2024 in #ratos-support
how do i get the goliath config? its not in any of my images files
i see the goliath has been added but i cant use it or find it on my version of ratos
6 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 3/30/2023 in #ratos-support
new manta m8p v1.1 addition in the configurator is not responsive
the dfu flashing is not responsive as well as sd card flashing. you cant check the board status or compile the firmware. if you click the button it does nothing. for some reason it just doesnt work. ive tried manually flashing but ive been in the weeds for 7 hours. any help would be awesome cause ive been waiting to use my new manta board with the added features. thanks for the support guys. i know im not the only one that will be grateful for any guidance
26 replies
RRCRat Rig Community [Unofficial]
•Created by moskeeter407 on 3/11/2023 in #fix-my-printer
I can’t get two btt tmc5160’s to work on my manta m8p
21 replies