eremit23
RRCRat Rig Community [Unofficial]
•Created by AOne on 2/7/2025 in #fix-my-printer
VAOC Cam freezing
And even if there is a hardware problem and a matter of wich usb port is used, still the cam can reconnect as a webcam while the VAOC software fails in econnecting until a whole raspi reboot. And at least that is a software issue and should be fixed.
18 replies
RRCRat Rig Community [Unofficial]
•Created by AOne on 2/7/2025 in #fix-my-printer
VAOC Cam freezing
Same with me.
And it's not that is used as a webcam but I declared additionally as a webcam because in that VAOC SOFWARE IT CONSTANTLY FREEZES.
Wich desables every aspect of an Idex printer.
18 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
(And with that, I'm done with the whole initial config. I can live with that freezing cam window... as long I can see it in another window.) But I don't dare to smash a champaign bottle onto the frame 🙂
28 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
Okay, did that. And it solved the Height Map Issue. And the VAOC (only that the z limit had to be lowered to -15 insted of -5)
Thank you for help and patience ! 💯
28 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
Update to higher RC's via Machine/Update/Update all Components? Or does this "higher RC" update requieres something different?
28 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
Wich had the result:
28 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
By doing the " DC endstop calibration" you probably referring to
9. Run the following command:
CALCULATE_DC_ENDSTOP
28 replies
RRCRat Rig Community [Unofficial]
•Created by eremit23 on 1/7/2025 in #ratos-support
Hi,
That is 2.1. RC2, officially marked as pre-release because of there is no documentation.
documentation is already publically available on the ratos website os.ratrig.com
Yeah, but it's still tells so on the release page.
28 replies
