Alemnath
RRCRat Rig Community [Unofficial]
•Created by DanO on 1/13/2025 in #fix-my-print
Idex torture test
didnt know there was prime tower option , my IDEX prints pretty good without , but this will help even more. Wish there was an AI auto circle finder for the VAOC , doing that a milliopn time before print is a PITA
5 replies
RRCRat Rig Community [Unofficial]
•Created by yamat on 1/11/2025 in #fix-my-print
Layer Shifts looking for help
also i see you have no panels on as well from your photos . your gonna have a lot of wobble on the Y . I printed braces untill my side panels get here to make the fram more rigid
33 replies
RRCRat Rig Community [Unofficial]
•Created by yamat on 1/11/2025 in #fix-my-print
Layer Shifts looking for help
I had same issue my fixes are the following : Make sure the gears on the stepper motors are all tight I had one loosen up on me = layer shift : use blue lock tight on the grub screws. and 2 : was I used the Black nozzle in the kit , which I thought was a .4mm nozzle , its not the black nozzle is a .6mm . The silver nozzle is the .4mm .
33 replies
RRCRat Rig Community [Unofficial]
•Created by Matthias on 1/10/2025 in #fix-my-printer
Clicking noise when moving gantry
Same problem here also
11 replies
RRCRat Rig Community [Unofficial]
•Created by yamat on 1/11/2025 in #fix-my-print
Layer Shifts looking for help
did you ever solve this ?
33 replies