spacebaby0695
RRCRat Rig Community [Unofficial]
•Created by spacebaby0695 on 10/27/2024 in #fix-my-printer
Heater fault
I just installed my second toolboard for the IDEX but whenever my heater gets to 245c I get a heater fault. It'll hold at 240 with no issues. I managed to pid tune it to 250 but then it'll go right back to faulting at 245. It's the Phaetus Rapido 2 with a pt1000. I'm not sure where to start. The wireing seems fine and like I said it works fine up to 240 and it will pid tune to 250
12 replies
RRCRat Rig Community [Unofficial]
•Created by spacebaby0695 on 10/27/2024 in #ratos-support
VAOC T1 x not lining up
I'm stuck. I line the two tool heads up in the VAOC config but then when it comes time to calibrate the z offsets T1 on the x doesn't line up with the probe. It's about 10mm off on the x. When I try to start over I get "Error evaluating 'gcode_macro _VAOC_CALIBRATE_TEMP_OFFSET:gcode': gcode.CommandError: Unexpected VAOC y-control point detected! Please run '_VAOC_RESET' to roll back to default values"
Also when I start the config the gantry hits the back of the machine. I think it's about 1mm off
58 replies