Steppe_Warrior
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 9/10/2024 in #ratos-support
Move exceeds maximum extrusion (2.673mm^2 vs 0.640mm^2)
16 replies
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 9/10/2024 in #fix-my-print
Ellis' Pressure Advance / Linear Advance Calibration Tool - not working on RatOS v2.1
13 replies
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 8/20/2024 in #fix-my-print
And here we go again... first layer problem even with beacon3D
80 replies
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 10/5/2023 in #fix-my-print
Very strange corners
4 replies
RRCRat Rig Community [Unofficial]
•Created by Steppe_Warrior on 3/14/2023 in #ratos-support
Can't access to http://ratos.local/configure
Greetings everyone!
I have experienced an issue with an extremely bad wifi connection of my Raspberry Pi 3 B+. Previously everything was fine and the location of the printer remains the same as before. So I was trying to change the wifi network, which resulted in a disconnection from my network. Now I can only connect via RatOS wifi. When trying to run a configurator to update the wifi setting I receive a "502 Bad Gateway" error.
Was trying to follow some guidance in this channel but unsuccessfully. For example, trying to run "pi@ratos:~/ratos-configurator$ pnpm start" resulted in an error. Since I consider re-flashing my Pi as the last resort, I would like to know your thoughts.
Thank you in advance!
16 replies