Low x accel
Title,even though my belt tension is somewhat good,my x axis accel is very low in comparison to the y axis
6 Replies
bruh
your belts are tight!!!!
too tight
also check your XY joiner idlers
they might not be moving freely
loosen the idler screws slightly until they can turn well
how do i see that the belts are to tight?
i actually think that his belt are too loose, the amplitude of the belt resonance is so low
Won't it get damped if too tight
Yes but if you look at the psd values on the left it is only in the e4 scale. Where a good example of belt resonance has values in e6 range
I think @auggie is right. When you look at the relative belt tension spectral density, its only 35000. Thats way too low for our printers. The X graph is 1e1 so at least that belt is too loose. Or Perhaps (Im guessing!) there is serious binding on one or more rails?